Journal of Power Sources

Journal: Journal of Power Sources

Abbreviation

J. power sources

Publisher

Elsevier

ISSN

0378-7753
1873-2755

Show all metadata

Search Results

Publications 1 - 10 of 92

In situ construction of potato starch based carbon nanofiber/activated carbon hybrid structure for high-performance electrical double layer capacitor
Li, Qianqian; Liu, Fu; Zhang, Li; et al. (2012)
Journal of Power Sources
Importance of 'unimportant' experimental parameters in Li-S battery development
Urbonaite, Sigita; Novák, Petr (2014)
Journal of Power Sources
From macro- to micro-single chamber solid oxide fuel cells
Buergler, Brandon E.; Ochsner, Mirjam; Vuillemin, Sibylle E.; et al. (2007)
Journal of Power Sources
Single chamber solid oxide fuel cells (SC-SOFCs) with interdigitating electrodes were prepared and operated in CH4/air mixtures. Both electrodes (Ni-Ce0.8Gd0.2O1.9 cermet and Sm0.5Sr0.5CoO3−δ perovskite) were placed on the same side of a Ce0.8Gd0.1O1.95 electrolyte disc. The separating gap between the electrodes was varied from 1.2 to 0.27 mm and finally down to 10 μm. Screen-printing was used for the preparation of the cells with a gap in the millimetre range, whereas micromolding in capillaries (MIMIC) was used for the preparation of the micro-SC-SOFCs. The prepared micro-SC-SOFCs consisted of an array of 19 individual cells that were connected in parallel having 100 μm wide electrodes. An open circuit voltage of 0.65–0.75 V was measured in flowing mixtures of methane and air. The maximum power density of 17 mW cm−2 was limited by the ohmic resistance of the long conduction paths along the thin electrodes to the active sites of the individual cells. The feasibility of the micro-cell was demonstrated by comparing the performance with the performance of the cells having feature sizes in the millimetre range. The cell resistance of micro-SC-SOFCs may be significantly reduced when connecting the cells in series using interconnections between anode and cathodes of adjacent cells.
A Comparative Analysis of Well-to-Wheel Primary Energy Demand and Greenhouse Gas Emissions for the Operation of Alternative and Conventional Vehicles in Switzerland, Considering Various Energy Carrier Production Pathways
Yazdanie, Mashael; Noembrini, Fabrizio; Boulouchos, Konstantinos (2014)
Journal of Power Sources
Exergetic analysis and optimization of a solar-powered reformed methanol fuel cell micro-powerplant
Hotz, Nico; Zimmerman, Raúl; Weinmueller, Christian; et al. (2010)
Journal of Power Sources
SEI film formation on highly crystalline graphitic materials in lithium-ion batteries
Buqa, Hilmi; Würsig, Andreas; Vetter, Jens; et al. (2006)
Journal of Power Sources
Behaviour of highly crystalline graphites in lithium-ion cells with propylene carbonate containing electrolytes
Buqa, Hilmi; Würsig, Andreas; Goers, Dietrich; et al. (2005)
Journal of Power Sources ~ Selected papers presented at the 12th International Meeting on Lithium Batteries : Nara, Japan, 27 June - 2 July, 2004
Wet-etching of precipitation-based thin film microstructures for micro-solid oxide fuel cells
Rupp, Jennifer L. M.; Muecke, Ulrich P.; Nalam, Prathima C.; et al. (2010)
Journal of Power Sources
Embedded fiber-optic sensing for accurate internal monitoring of cell state in advanced battery management systems part 1: Cell embedding method and performance
Raghavan, Ajay; Kiesel, Peter; Sommer, Lars Wilko; et al. (2017)
Journal of Power Sources
A flexible direct methanol micro-fuel cell based on a metalized, photosensitive polymer film
Weinmüller, C.; Tautschnig, G.; Hotz, N.; et al. (2010)
Journal of Power Sources

Publications 1 - 10 of 92

Journal: Journal of Power Sources

Abbreviation

Publisher

Journal Volumes

ISSN

Description

Filters

Search Results