Bed-Load Diversion with a Vortex Tube System
Loading...
Author / Producer
Date
2019-09-06
Publication Type
Conference Paper
ETH Bibliography
yes
Citations
Altmetric
Data
Rights / License
Abstract
Impaired sediment connectivity in river systems due to transversal hydraulic structures is a primary cause of channel narrowing and down-cutting, as well as reduced morphodynamic variability. Among various restoration measures, the vortex tube is a structural measure to re-establish bed-load conveyance during flood events at low-head hydraulic structures. Bed-load particles are entrained through a slit in the tube soffit and sluiced from an upper channel to a lower parallel channel. This paper presents and compares the results of two laboratory model studies on the optimal design of vortex tubes for run-of-river hydropower plants. Although the two case study hydropower plants are situated within 1.5 km distance along the same river, differences in boundary conditions considerably reduce the suitability of one of the plants for the effective operation of a vortex tube. The test results show that the energy head difference between the two channels is a decisive hydraulic boundary condition and should be larger than approx. 1 m at all times. The dimensions of the vortex tube should be adapted to the grain sizes of the transported bed-load. If the vortex tube does not span the entire channel width, an open tube end is recommended to increase its zone of influence. A diversion efficiency of 94% was determined for the optimal design. The present findings demonstrate that vortex tubes may be an appropriate structural measure to re-establish sediment continuity at hydraulic structures, primarily where the upstream and downstream channels are located in close proximity.
Permanent link
Publication status
published
External links
Editor
Book title
Journal / series
Volume
Pages / Article No.
5900 - 5909
Publisher
International Association for Hydro-Environment Engineering and Research
Event
38th IAHR World Congress: Water Connecting the World
Edition / version
Methods
Software
Geographic location
Date collected
Date created
Subject
vortex tube; sediment connectivity; bed-load transport; bed-load diversion
Organisational unit
03820 - Boes, Robert / Boes, Robert
Notes
Conference lecture held on September 6, 2019
Funding
727830 - Fishfriendly Innovative Technologies for Hydropower (SBFI)