Dario Chieppa
Loading...
4 results
Filters
Reset filtersSearch Results
Publications 1 - 4 of 4
- Fäh, Donat; Duvernay, Blaise; Michel, Clotaire; et al. (2024)Mit seinem Beschluss vom 18. Februar 2009 hat der Bundesrat den Antrag für die Erneuerung des Starkbebennetzes der Schweiz (Phase 1) gutgeheissen und deren Realisierung in Auftrag gegeben. Das Projekt umfasst in dieser ersten Phase (2009‐2013) die Installation und Inbetriebnahme von 30 modernen Erdbebenstationen. Diese sollen in erster Linie bestehende Lücken in der nationalen Überwachung schliessen. Dabei wurden alte Stationen teilweise ersetzt, aber auch neue Standorte realisiert. Im Rahmen des Projektes wurden neue Standards für die Installation von Starkbebenstationen definiert. Aufgrund der erfolgreichen ersten Phase hat der Bundesrat mit seinem Beschluss vom 30. Januar 2013 der Realisierung der zweiten Phase der Erneuerung des Starkbebenmessnetzes (2013‐2023) zugestimmt. In dieser zweiten Phase werden 70 Starkbebenmessstationen gebaut, davon vier Bohrlochinstallationen. Abbildung 1 gibt einen Überblick über die 100 Starkbebenstationen, die in den Phasen 1 und 2 installiert wurden. Beide Projektphasen wurden von einer Steuerungsgruppe unter der Leitung des Bundesamts für Umwelt (BAFU) begleitet. Für alle installierten Stationen wurde eine Standortcharakterisierung durchgeführt. Dabei kamen Ein‐Stations‐Methoden der seismischen Bodenunruhe, passive Arraymessungen und aktive seismische Messungen zum Einsatz. An Standorten mit besonderen Bodeneigenschaften, die bei Erdbeben zu nichtlinearem Materialverhalten oder Bodenverflüssigung neigen, wurden CPT‐ Messungen durchgeführt. Die Standortcharakterisierung wurde für jeden Standort in einem Bericht zusammengefasst. Die Messdaten und Auswertungen wurden in einer Datenbank gespeichert. Eine Beschreibung der Standorte und die Berichte zur Standortcharakterisierung sowie die Erdbebenaufzeichnungen der Starkbebenstationen sind auf den Webseiten des Schweizerischen Erdbebendienstes zugänglich.
- Identification of Subsurface Structures Using H/V Curves from Earthquake Recordings: Application to Seismic Stations in SwitzerlandItem type: Journal Article
Pure and Applied GeophysicsChieppa, Dario; Hobiger, Manuel; Nagashima, Fumiaki; et al. (2023)We performed a study to test the performances of the Hybrid Heuristic Search (HHS) algorithm (Nagashima et al. 2014) using earthquake recordings at 23 instrumented sites in Switzerland. The HHS algorithm is based on the diffuse field theory and estimates the P- and S-wave velocity profiles by inverting horizontal-to vertical spectral ratio (H/V) curves of earthquake recordings. In this study we inverted the H/V curves computed using the arrivals of local and regional earthquakes with a maximum local magnitude of 4.6. We compared the results of the inversion technique to the information available for each investigated site (e.g., site characterization analysis). Our results emphasize the importance of site characterization data for the definition of the parameter space in the near surface, and the potential to extend the investigated depth to much higher depths than the standard site characterization measurements. The additional constraints in the inversion are important to drive the inversion towards a unique solution. Our analysis confirms the potential of the HHS algorithm to invert the full earthquake H/V curve for subsurface investigation and its applicability to areas with low magnitude earthquakes. In addition, the HHS algorithm can be a useful technique to investigate deeper structures and extend the velocity profile to depths that are not resolved by classical site characterization techniques. - Shear-wave velocity profiles and their relationship with empirical amplification functionsItem type: Conference Paper
Proceedings of the Third European Conference on Earthquake Engineering and Seismology – 3ECEESPanzera, Francesco; Chieppa, Dario; Bergamo, Paolo; et al. (2022)From a one-dimensional shear-wave velocity profile, the quarter-wavelength approach allows computing travel-time averaged parameters such as velocity and impedance contrast. The advantage of such a procedure is the possibility of relating the averaging depth to a specific wavelength, thus making the result frequency-dependent. In this study we converted a set of velocity profiles into its quarter-wavelength representation. Results are then correlated with empirical amplification functions. For this purpose, we use a database of empirical amplification functions and shear wave profiles of the Swiss seismic network. We demonstrate that quarter-wavelength parameters can be used as proxy for seismic site characterization of rock and soft sediment sites and to derive site-dependent amplification functions. - Ongoing work for the study of site amplification phenomena in the Swiss alpine valleys and their implication for the Swiss building codeItem type: Other Conference Item
Abstract Volume 21st Swiss Geoscience MeetingBergamo, Paolo; Chieppa, Dario; Panzera, Francesco; et al. (2023)
Publications 1 - 4 of 4