Suche
Ergebnisse
-
Compensation of cutting fluid influences on five axis machine tools
(2016)The Proceedings of MTTRF 2016 Annual MeetingConference Paper -
Compensation of Thermal Effects on Machine Tools using a FDEM Simulation Approach
(2009)International Conference and Exhibition on Laser Metrology, Machine Tool, CMM and Robotic PerformanceConference Paper -
Thermo energetic issues in 5-axis machine tools
(2017)Proceedings of the MTTRF 2017 Annual MeetingConference Paper -
An approach for developing meta models out of fluid simulations in enclosures of precision machine tools
(2016)Annual Meeting Volume ~ Proceedings of the 31st Annual Meeting of the American Society for Precision EngineeringConference Paper -
Comparing the thermo-machanical-behavior of machine tool frame designs using a FDM-FEA simulation approach
(2007)Proceedings of: the twenty-second annual meetingConference Paper -
Quality Control of mass-produced Proton Exchange Membrane Fuel Cells
(2014)Høgskolen i Gjøviks rapportserie ~ Proceedings from the CIRP Research Affiliate Workshop 2014Conference Paper -
Calculating Thermal Location and Component Errors on Machine Tools
(2009)Proceedings of : the twenty-fourth annual meeting of the American Society for Precision Engineering, October 4 to 9, 2009, Monterey Marriott Hotel and Monterey Conference Center, Monterey, CaliforniaConference Paper -
Shop floor conditions versus precision on 5-axis machine tools
(2015)Laser metrology and machine performance XI: 11th International Conference and Exhibition on Laser Metrology, Machine Tool, CMM & Robotic Performance, Lamdamap 2015Conference Paper -
Dynamic loads and thermal errors on machine tools
(2012)The 13th Mechatronics Forum International ConferenceConference Paper -
Extended discrete R-Test as on-machine measurement cycle to separate the thermal errors in Z-direction
(2020)Proceedings of Special Interest Group Meeting: Thermal IssuesThis paper presents an on-machine measurement cycle based on the discrete R-Test, which separate the thermal errors of the different machine components in Z-direction. The error separation in Z-direction is particularly required for five-axis machining processes. The extended discrete R-Test separates the thermal position and orientation errors of a vertical rotation axis, the thermal errors of the machine table and the thermal position ...Conference Paper